Snorkel SL30SL-sn50001+ User Manual download pdf (Page 12)

Page 8 Operation Manual

Operation

PERATION

Before operating the work platform, ensure that the Pre-Operation Safety Inspection has been completed

and that any deficiencies have been corrected. Never operate a damaged or malfunctioning machine.

The operator must be thoroughly trained on this machine.

TARTING

THE

NGINE

1. Mount the platform and properly close the entrance.

2. Depress and hold the GLOW PLUG button for approximately 5 seconds.

3. Press green START button.

RAVEL

ITH

THE

LATFORM

OWERED

1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and debris),

is level, and is capable of supporting the wheel loads.

2. Verify that the Engine is started and the Chassis Emergency Stop Switch is ON (pulled out).

3. Mount the platform and properly close the entrance.

4. Check clearances above, below, and to the sides of platform.

5. Twist the Platform Emergency Stop Switch out to the ON position.

6. Select DRIVE mode.

NOTE: Choose between standard drive and extra torque depending on the gradient.

7. Engage the Safety Interlock Trigger and move the Joystick to FORWARD or REVERSE to travel in the

desired direction. The speed of the machine will vary depending on how far from center the Joystick is

moved.

TEERING

1. Turn the Drive/Lift Switch to DRIVE.

2. While engaging the Safety Interlock Trigger, push the Steering Switch to RIGHT or LEFT to turn the

wheels in the desired direction. Observe the tires while maneuvering the work platform to ensure proper

direction.

NOTE: Steering is not self-centering. Wheels must be returned to the straight ahead position by

operating the Steering Switch.

LEVATING

THE

LATFORM

1. Select a firm, level surface.

2. Select LIFT mode.

3. While engaging the Safety Interlock Trigger, push the Joystick forward.

4. If the machine is not level the tilt alarm will sound and the machine will not lift or drive.

5. If the tilt alarm sounds the platform must first be fully lowered, then elevate the platform approximately

600mm (2ft), stop, press and hold the LEVEL button until the tilt alarm is silenced. Only then can you

elevate fully. If the platform is not levelled correctly the tilt alarm will continue to sound and lift functions

will be cut at a height of approximately 2m (6ft).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 103 104

Comments to this Manuals

No comments

Snorkel SL30SL-sn50001+ User Manual Page 12

Comments to this Manuals

Related products and manuals for Special machinery Snorkel SL30SL-sn50001+